Heights from bottom rim or HCL and Maximum Frame Width

When a new order is entered then the default value for the height direction depends on the value of the height entered.  If it is greater than 10 then a value from bottom rim is set as the default and if not then a HCL measurement is set as the default - which direction depends if a bifocal lens has been chosen.

There is a now an entry in settings (Job Entry / Check / Bifocal Change Point) where the default value of 10 can be altered so if the convention is that measurements are always from bottom rim then this can be catered for by making the appropriate setting.

There is also a similar setting for specifying the maximum frame width - default is 70.