Squeeze / Wiggle room

There are a couple of features which allow orders where the minimum size uncut is calculated to be just above a catalogue diameter.

For finished lenses there is a setting in Job Entry / Finished Lens Diameter / Still use finished if MSU exceeds diameter by.

If this is set to 1 then diameters up to 71mm will still pick a 70mm finished lens.

For Rx lenses, there is a setting Calculation / Show Squeeze in.  This will enable a link on the order entry screen "Squeeze". If this is clicked then the glazing allowance is reduced to 0.1mm.

In addition, if the PD is wished to be changed to make the lens fit, then there is  ? by the PD. If this is clicked then a table will be shown. This will indicate the diameter calculated for different PDs and whether it is acceptable according to standards.