Surface Both lenses and Surface plus powered lenses where a shape was provided.

There are two new settings in the settings editor.

Plus Powers with Standard Shapes: This is used to indicate that the lab want to operate so that if a standard shape or a drawing is selected for a plus power then this can be set to signify that the user wants an optimised lens.  You can still tick the finished checkbox to force the lens to be taken from finished.

Surface Both is one lens is surfaced.  This is used to indicate that the lab will operate by surfacing both lenses, this is generally to ensure coating, transitions colour matching and base curves agree.

Both of these are not applicable if the customer record indicates that the customer prefers price over cosmetic.

There is also a refinement to the prefer 65mm setting so that it takes into account any potential saving from using a 55mm or 60mm finished lens. The tendency will be that low plus powers will go to a 65mm but that higher powers will go to a lower diameter.